Acclaim Lighting ISO13405 Camera Accessories User Manual


 
SAFETY NOTICE
4
ATTENTION USERS:
Manufacturing date code on serial number label is in the format:MONTH YYYY.
Markings.
The following terms or symbols are used on the equipment or in this manual
to denote information of special importance:
Alerts users to important Operating
and Maintenance instructions. Read
carefully to avoid any problems.
Indicates type B equipment
in accordance with IEC
60601-1
GENERAL
This equipment has been designed to minimize exposure of personnel to hazards.
While the Acclaim System is designed for safe operation, certain precautions must
be observed. Use of the Acclaim System not in conformance with the instructions
specified in this manual may result in permanent failure of the unit.
KNOWLEDGE OF WARNINGS AND CAUTIONS
Users must exercise every precaution to ensure personnel safety, and be familiar
with the warnings and cautions presented throughout this manual and summa-
rized below.
CAUTION: There are no user-serviceable parts inside. Servicing should be
performed by qualified dealer service representatives only.
Connecting any device to the Acclaim System that does not meet the equiv-
alent safety requirements of the system may reduce the safety effectiveness
of the Acclaim System.
Unplug the system components from power before performing cleaning
procedures.
WARNING: To prevent fire or electrical shock, do not expose this equipment
to rain or moisture.
Do not spray cleaning liquids or disinfectants directly on the camera hand-
piece or the USB Umbilical. Use care not to allow liquids to run into inter-
nal circuitry.
Do not wipe the surfaces using benzine, thinner, etc. as this may degrade
the finish.
DO NOT ATTEMPT INTERNAL SERVICE
The interior of each component of the Acclaim System is only accessible by
removing hardware with tools and should only be opened and serviced by an
authorized service technician. Please contact your local authorized dealer for
service. Failure to heed this warning may result in equipment damage and void-
ing the warranty.
2
Alerts users that the infection control sheath must be
used for only one patient and disposed of properly in
accordance with local code.