Filter
Top Products
724-746-5500 | blackbox.com
Page 16
CCTV Tester
PROTOCOL Pelco P > PTZ protocol of camera
COM 485 > PTZ communication port type
RATE 4800 > PTZ baud rate: 2400/4800/9600/19200
SPEED 016 > PTZ pan and tilt speed
IDLE TIME 000 > Battery saver turn off time (minutes)
BATTERY 090 > Battery status (%):100/90/75/50/25/5
Figure 3-3. Typical configuration.
MODIFYING THE SETTINGS:
ENTER SETUP MODE: Press “SET.” In this mode you 1) modify the PTZ settings
(Protocol, Com, Rate and Speed) to match the camera you are testing and 2) set the
battery saver turnoff time (when no activity).
SELECT THE ITEM: Press the “UP and DOWN arrows” to blink the line you wish to
modify. Battery status (% remaining) cannot be modified.
ADJUST THE PARAMETER: Press the “UP/DOWN/RIGHT arrow.”
SAVE/EXIT. Press the “LEFT arrow” to save the setting. Press the “LEFT arrow”
again to stop the blinking. Exit by holding the “MENU key” to return to the Main
Menu.
NOTE: The CCTVTEST has 20 PTZ protocols and 17 speed settings (1 is the slowest
and 16 is the fastest).
3.4.2 Selection 2: Video, Signal Strength, and PTZ Test
A. Display a camera’s video signal on the LCD and monitor:
CONNECTION: Connect the camera to the tester as shown in Figure 3-1. The
camera connects to the tester’s VIDEO IN jack.
Display camera video: Press “2” on the keypad to turn ON the tester’s video and PTZ
feature. The camera’s video appears on the color LCD display. The camera’s video
will also appear on a monitor (if connected to the tester’s VIDEO OUT jack). Study
the image for proper focus and viewing angle. Study the voltage readout (below)
for proper amplitude. And use the tester’s PTZ feature (below) to control pan, tilt,
and zoom.