Black Box CCTV Tester Camera Accessories User Manual


 
724-746-5500 | blackbox.com Page 19
Chapter 3: Operation
SELECT UTP CABLE TEST MODE: Press the “3” key to enter the UTP test mode.
START TEST: Press “SET.” The CAT5/6 UTP cable wire map will be displayed on the
LCD screen.
RETURN TO MAIN MENU: Hold the MENU key to return to the Main Menu.
UTP CABLE TEST
TESTER SIDE 1 ---------------------- 1 REMOTE
PIN NUMBERS 2 ---------------------- 2 PIN NUMBERS
3 ---------------------- 3
Typical CAT5/6 4 ---------------------- 0 ”0” means open
Cable (UTP) 5 ---------------------- 0 Two “0”s is a
Wiremap 6 ---------------------- 6 short circuit
7 ---------------------- 7
8 ---------------------- 8
Figure 3-5. UTP cable test wiremap.
3.4.4 Selection 4: Video Generator: Testing a monitor using the VIDEO OUT port.
Connection. Connect the monitor to the tester using the VIDEO OUT jack:
Without camera
With camera
Figure 3-6. Video generator test setup.
Drive the monitor with the tester’s video generator. Or drive the monitor
with a camera “looped” through the tester.
SELECT VIDEO GENERATOR MODE: Press the “4” key to turn ON the video
generator.