Black Box CCTVTEST Camera Accessories User Manual


 
724-746-5500 | blackbox.com
Page 14
CCTV Tester
3. Operation
3.1 Power and Battery
POWER: The power ON/OFF switch is located on the side of the tester.
BATTERY SAVER: The tester has a battery-saving sleep mode. Turn the slide switch
ON again if the tester is asleep.
RECHARGEABLE BATTERY: The tester has a non-removable battery for a larger
capacity. Do not open the rear panel and attempt to repair it.
CHARGE TIME: The battery requires five hours for a full charge.
CHARGE LED: While charging, the “Charge” LED will be ON.
OPERATING TIME: Approximately 10 hours.
WHEN TO RECHARGE: Recharge when the battery indicator in the System Setup
menu shows 25% or less.
USE WHILE CHARGING: The tester can be used during charging.
3.2 Main Menu Introduction
Turn on the device. The Main Menu appears: #1 is the setup mode. #2 thru #6
selects five test modes. Use the keypad’s numbered buttons to select the menu
item. The last item is the software version and serial number.
MAIN MENU
1 SYSTEM SETUP > Set up PTZ and check battery
2 VIDEO AND PTZ TEST > Test video and control PTZ
3 UTP CABLE TEST > Test UTP cables
4 VIDEO GENERATOR > Test video monitors
5 RS485 DATA TEST > Analyze RS-485 protocol
6 MULTIMETER > Measure voltage/resistance
VER:V1.11 S/N:08110910 > Software version and S/N
Figure 3-1. Main Menu.