Bushnell 780005 Camera Accessories User Manual


 
2
Using the Digiscoping Bracket with Your Camera and Spotting Scope
Loosen the silver hinge lock screw (A) until the camera column on the bracket can be rotated 1.
into a vertical position as shown in the photo, then tighten the screw.
Attach your tripod to the tripod mounting block on the bracket. The black lever on the rear 2.
of the tripod mounting block (B) loosens it, if you need to adjust the overall weight balance
once the scope and camera have been attached.
Loosen the silver screw (C) on the scope mounting block to lift and remove the quick release 3.
platform, and attach it to your scope using a coin to turn the screw under the quick release
platform. Place the platform with mounted scope back on the mounting block and tighten
the silver screw to secure the scope in place. Loosening the black lever (D) on the rear of the
scope mounting block allows you to slide the scope on the bracket until it is balanced and in
a good position relative to the camera.
Loosen the silver screw (E) on the camera mounting block, lift and remove the quick release 4.
portion, and attach your camera to it using the tripod screw (F) at the top. Replace the block
with mounted camera, and tighten the silver screw.
Position the camera so its lens (turn on compact cameras so the lens is at its normal operating 5.
position) is close to the eyepiece lens (ocular), and centered. Loosen the black levers and
turn knobs as needed to move:
the scope’s horizontal position relative to the camera (loosen D), •
the camera’s vertical position (loosen G rotate H), •
the camera’s horizontal position (I)•
tilt angle of the camera (J)-especially useful if your scope has an angled eyepiece. •
Tighten the levers/knobs after adjustment to prevent accidently moving the camera or
scope (avoid overtightening). Please refer to “Digiscoping Tips” before taking any photos.
Loosening the black lever (K) allows you to swing the camera out away from the scope when 6.
you wish to view through the eyepiece normally, without removing the mounted camera.
When you are ready to pack up your equipment, loosen the silver screws (C,E) that hold the 7.
camera and scope mounting blocks in place-leaving them on the camera and scope will
save setup time when you use the bracket again. Tighten the silver screws so they aren’t lost.
To collapse the bracket, loosen the hinge lock screw (A) and fold the vertical column against
the horizontal bar. Don’t change any mounting block positions for faster setup next time.
Tripod
Mounting
Block
C
E
F
I
Vertical
Camera
Column
H
Front View Rear View
Camera
Mounting
Block
J
Scope
Mounting
Block
A
B
D
GH
K
Horizontal Bar
780005 Lg Digiscoping Bracket 5LIM-rev100708.indd 2 10/8/2008 9:19:48 AM