Filter
Top Products
116
Cleaning the CMOS Imaging Element
● Never disconnect the camera power during cleaning. If the power is cut off, the
shutter will close and possibly damage the shutter curtain.
● Use a blower without a brush attached. Using a brush to remove dust from the
image element can damage the element.
● Do not insert a dust blower into the camera beyond the lens mount. If the power
shuts off and the shutter closes, this may damage the shutter curtains.
● Never use cleaning sprays or blower sprays. The pressure and freezing action
of the spray gas may damage the surface of the imaging element.
5
Select [1: Enable].
● Turn the < > dial to select [1: Enable],
then press the <
> button.
➡ The message “
” appears on the
LCD panel.
● If “
” is blinking on the LCD panel, set the
Main Switch to <OFF> and remove the
battery pack. Then repeat the procedure
from Step1.
6
Press the shutter button down
fully.
● The reflex mirror of the camera then flips
up, and the shutter opens.
7
Clean the imaging element.
● Carefully blow any dust off the imaging
element using a commercially available
blower.
8
Finish cleaning.
● Set the Main Switch to <OFF>.
➡ The camera power turns off, the shutter
closes and the mirror is lowered.
● Set the Main Switch to <ON> again, and
the camera will be ready to shoot pictures
normally.