Filter
Top Products
5
Installation
1. Drill a hole for wiring to exit
the wall.
2. Feed camera pigtail through
the base of the wall mount.
3. Attach mount to wall with
screws.
4. Connect camera pigtail to the
base of the camera.
5. Secure the camera to the
mount using the set screw.
6. Connect the camera
pigtail to wire extensions
or directly to a video
display system.
7. Connect the BNC video
output to a monitor or
distribution system.
8. Connect RS-485 wires to
PTZ controller.
9. Connect power supply.
Power Supply
RS-485
Connector
Set Screw
Wall Mount
Camera
Pigtail
Note: The installation of the 6154 camera is shown below. The 6144 comes with a different
mount, but the installation is otherwise identical.
Crimp-on splice
connectors
(not included)
Wire Extensions
(not included)
To Video
Display
To PTZ
Controller
BNC connector