Chauvet DMX512 Camera Accessories User Manual


 
1. BEFORE YOU BEGIN
What is included
¾ 1 x SX Gobo™
¾ EHJ 24V 250W Lamp
¾ 7 Replaceable Gobos
¾ Warranty Card
¾ User Manual
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that
all parts are present, and have been received in good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture
must be returned to the factory, it is important that the fixture be returned in the original factory box
and packing.
AC Power
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating is its average
current draw under normal conditions. All fixtures must be powered directly off a switched circuit and
cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used solely for a 0% to 100% switch. Before applying power to a fixture, check that the
source voltage matches the fixture’s requirement.
Warning! Verify that the voltage required by your unit matches the line voltage applied.
Damage to your fixture may result if the line voltage applied does not match the
voltage required by the fixture. All fixtures must be connected to circuits with a
suitable Earth Ground.
Contact Us
World Wide
General Information Chauvet Lighting
3000 North 29
th
Court
Hollywood, FL 33020
voice: 954.929.1115
fax: 954.929.5560
toll free: 800.762.1084
Technical Support Chauvet Lighting
3000 North 29
th
Court
Hollywood, FL 33020
voice: 954.929.1115 (Press 4)
fax: 954.929.5560 (Attention: Service)
World Wide Web www.chauvetlighting.com
SX Gobo Manual 3
2006-12-11/15:16