Cisco Systems 2900 Security Camera User Manual


 
1-11
Cisco Video Surveillance IP PTZ Dome Camera User Guide, Cisco 2900 Series IP Dome
OL-24281-01
Chapter 1 Installation
Switch Settings
Step 3 Tighten the captive Phillips pan head screws to secure the lower dome (see Figure 1-12).
Figure 1-12 Installing the Pendant Lower Dome
Switch Settings
Table 1-3 shows SW2 switch settings.
Note If you are using Pelco D-type or Pelco P-type control, your system may not operate if the baud rate and
address switches are not set correctly. The switches are set at the factory using the defaults for
Pelco D-type control (2400 baud and address 1).
Ta ble 1-3 Switch Settings for SW2
Special Systems
Switch Number 1 2 3 4 5 6 7 8 9 10
AD-32 Preset System ON
CM9502 Setting ON
Serial Port Settings
Switch Number 1 2 3 4 5 6 7 8 9 10
RS422 OFF OFF
RS485, 4-Wire OFF ON
RS485, 2-Wire ON ON