Cisco Systems 4300 Security Camera User Manual


 
3-10
Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
OL-19609-04
Chapter 3 Configuring and Managing the IP Camera
Feature Setup Windows
Event Notification Window
The Event Notification window provides options for how the IP camera handles events. An event is any
of the following:
A change of state from low to high or from high to low on an input port of the IP camera. For related
information about input ports, see the “IO Ports Settings Window” section on page 3-8.
Motion that the IP camera detects. For related information about motion detection, see the “Motion
detection controls” rows in Table 4-1.
Loss of video signal.
When an event occurs, it triggers the IP camera to take certain configured actions:
HTTP notification—IP camera sends notification to a remote system via HTTP. This information
includes the following:
Device ID—ID of the IP camera
Device name—Name of the IP camera
IP address—IP address of the IP camera
MAC address—MAC address of the IP camera
Channel ID—Channel identification number (1 for primary stream or 2 for secondary stream)
Channel name—Name that is configured for the channel
Date and time—Date and time that the event occurred
Active post Count—Sequence number of the notification for this event
Event type—Type of event
Table 3-6 Pan Tilt Settings Window Options
Option Description
Pan/Tilt Area
Pan and Tilt Enabled Check this check box to enable pan and tilt operation for the IP camera.
Protocol Display only. Indicates the protocol for the pan/tilt functionality.
Address Enter the logical address of the external PTZ device.
To determine this address, refer to the documentation for that device.
RS-232 Settings
Baud Rate Choose the Baud rate value that is configured on the device that controls the
pan and tilt functions of the IP camera.
The default setting is 4800 bps.
Data Bits Display only. Indicates the data bits configuration for the serial port on the
IP camera.
Parity Display only. Indicates the parity configuration for the serial port on the IP
camera.
Stop Bits Display only. Indicates the stop bits configuration for the serial port on the
IP camera.