Filter
Top Products
3-40
Cisco Video Surveillance 4300E and 4500E High-Definition IP Camera User Guide
OL-25230-02
Chapter 3 Configuring and Managing the IP Camera
Log Windows
CONFIG_SAVE_FAILED Saving configuration to user <user>
<IP address or hostname> failed.
A user attempt to save the IP camera
configuration failed.
3
CONFIG_SAVED Configuration saved by user <user>
<IP address or hostname>.
The IP camera configuration was saved
by a user.
5
CONFIG_UPLOAD_FAILED Uploading configuration failed from
user <user> <IP address or hostname>.
A user attempt to import the IP camera
configuration failed.
3
CONFIG_UPLOADED Configuration uploaded from user
<user> <IP address or hostname>.
The IP camera configuration was
imported by a user.
5
DEFAULTS_FAILED Restoring factory defaults failed for
user <user> <IP address or hostname>.
An attempt to reset the IP camera to its
factory default configuration failed.
3
DEFAULTS_RESTORED Factory defaults restored successfully
by user <user> <IP address or
hostname>.
The IP camera was reset to its factory
default configuration.
5
DEVICE_REBOOT_AUTO Device rebooted. The IP camera rebooted automatically. 5
DEVICE_REBOOT_MANUAL Device was rebooted manually by user
<user> <IP address or hostname>.
The IP camera was rebooted by a user. 5
DHCP_LEASE DHCP lease renewal was successful. The IP camera renewed its DHCP
lease.
6
DSP_ENCODING_HALTED The Codec/Sensor module’s DSP
encoding was halted. Either the analog
image signal from the sensor has been
lost, or an internal encoding error has
occurred.
The DSP of the IP camera codec/sensor
module DSP stopped encoding. The
analog image signal from the sensor
may be lost or an internal encoding
error may have occurred.
2
EMAIL_TRIGGERED Event triggered: email sent to <e-mail
address>.
An event occurred and e-mail
notification of the event was sent.
5
ETH_BER Bit Error Rate (BER) exceeded
specified threshold of <threshold>.
The bit error rate (BER) exceeded the
specified threshold.
4
ETH_SIGNAL_DEGRADE Ethernet signal degrading. The IP camera detected a degrading
Ethernet signal.
4
FRAMES_DROPPED Output frame rate does not match the
camera’s configured frame rate.
The IP camera is sending video at a
frame rate that does not match the
configured frame rate.
3
FW_UPGRADE_FAILED Upgrading firmware failed from user
<user> <IP address or hostname>.
An attempt to upgrade the IP camera
firmware failed.
0
FW_UPGRADED Firmware upgraded successfully from
user <user> <IP address or hostname>.
The IP camera firmware was updated. 5
HTTP_TRIGGERED Event triggered: notification sent to
HTTP server <IP
address or
hostname>.
An event occurred and HTTP
notification of the event was sent.
5
INPUT_ONE_CHANGED Input port one changed to <high/low>. Input port 1 on the IP camera changed
state.
5
INPUT_ONE_RESET Input port one reset to <high/low>. Input port 1 on the IP camera reset to
its default state.
5
Table 3-25 Log Messages
Message Name Description that Appears in Log File Explanation Severity