Filter
Top Products
2-2
Cisco Video Surveillance 5010/5011 Indoor Fixed HD IP Dome Camera User Guide
OL-22669-02
Chapter 2 Installation
In-Ceiling Installation
c. Connect the auto iris lens to the 4-pin connector located on the side of the camera. Pin connections
for the iris drive connector are as follows:
Figure 2-1 Lens Pin Connections
Step 3 Connect the wiring to the side of the back box:
a. Plug the network cable into the RJ-45 network port on the side of the camera. If the network has no
PoE, connect a 24 VAC Class 2 power supply to the 24 VAC power connector. Refer to
“Wiring”
section on page 2-10 for wiring connections.
b. Connect the necessary wiring for alarms and relays (refer to “Wiring” section on page 2-10 more
information.)
Step 4 Install the back box by compressing the spring clips and pushing the back box through the hole. Tighten
the machine screws completely to secure the back box to the ceiling.
Figure 2-2 In-Ceiling Installation
Step 5 Apply power to the camera. The camera will complete a configuration sequence; the green LED flashes
five times per second for approximately two minutes and then turns solid after the sequence is complete.
Note If the camera is not connected to a DHCP server and DHCP is enabled, the configuration
sequence might take up to five minutes to complete.
Pin DC (AID) Auto Iris Lens
1 Control coil negative (–)
2 Control coil positive (+)
3 Drive coil positive (+)
4 Drive coil negative (–)
3
12
4
278768
278781