Cisco Systems CIVS-IPC-2630V Security Camera User Manual


 
2-4
Cisco Video Surveillance 2630 IP Dome User Guide
OL-24130-02
Chapter 2 Getting Started
Installing the Cisco Video Surveillance 2630 IP Dome
Mounting with a Conduit Base
You can mount the 2630 IP dome with an optional conduit base (CIVS-IPCA-1006=) in situations where
you cannot cut a hole through a surface for cables or where cables run through a small hole in a surface.
To mount the IP camera with a conduit base, perform the following steps:
Note When you disassemble the IP dome for mounting as described in these steps, make sure to remove any
protective packing material that is installed between components.
Procedure
Step 1 Remove the dome assembly by unscrewing the three security TORX screws and pulling the dome away
from the base plate (see
Figure 2-2).
Use the TORX screwdriver that is provided with the IP dome to unscrew these screws.
Figure 2-2 Disassembling the 2630 IP Dome Components
1 Base plate
2 Camera unit
2
1
3
4
5
6