Cisco Systems CIVS-IPC-2630V Security Camera User Manual


 
2-7
Cisco Video Surveillance 2630 IP Dome User Guide
OL-24130-02
Chapter 2 Getting Started
Installing the Cisco Video Surveillance 2630 IP Dome
To connect a power cable, use a flat-head screwdriver to depress the brown tabs on the power input and
connect bare positive, negative, and ground wires as shown on the label that is affixed to the IP dome.
Step 11 (Optional) Connect an external speaker, microphone, or both to the Y cable, then connect the Y cable to
the audio port on the IP dome.(see
Figure 1-1 on page 1-3). The Y cable that is included in the optional
audio/video cables accessory kit can be purchased from Cisco (Cisco part number CIVS-IPCA-1017=).
Each device connects to the audio cable through a standard 3.5 mm mini phone jack. A speaker connects
to the green jack, which is labeled “Audio Out.” A microphone connects to the pink jack, which is labeled
“Audio In.”
Step 12 (Optional) Use the GPIO ports to connect external devices that trigger alarms (connect through alarm
input ports) or respond to alarms (connect through alarm output ports).
See Figure 1-1 on page 1-3.
Step 13 Attach the camera unit to the base plate by aligning the three tabs on the camera unit with the slots on
the base plate, pressing the camera unit into the base plate until the tabs snap into place, and securing
the camera unit with the two camera unit screws (see
Figure 2-5).
Figure 2-5 Attaching the Camera to the Base Plate
1 Base plate
2 Camera unit