Cisco Systems CIVS-IPC-2630V Security Camera User Manual


 
2-8
Cisco Video Surveillance 2630 IP Dome User Guide
OL-24130-02
Chapter 2 Getting Started
Installing the Cisco Video Surveillance 2630 IP Dome
Step 14 See Figure 2-13 on page 2-18 and take these actions to adjust the camera lens to obtain the desired
image:
Temporarily attach an analog monitor to the IP dome so that you can see video while adjusting the
camera. If the cable from the monitor terminates with a 3.5 mm jack, plug it into the analog video
output port on the IP dome. If the cable terminates with a BNC connector, connect it to the mini
cable with BNC adapter, then plug the cable into the analog video output port. The mini cable with
BNC adapter is included in the audio/video cables accessory kit, which you can purchase from Cisco
(Cisco part number CIVS-IPCA-1017=).
Make the following adjustments, viewing the video on the analog monitor as needed:
Back focus—The back focus is factory set for optimal use and should not require adjustments.
In the event that it does need to be adjusted, use the 0.9 mm Allen wrench that is supplied with
the IP camera to loosen the three back focus hex screws, then adjust the back focus by aiming
the IP camera at an object that is at least 15 feet (4.5 meters) away and gently sliding the lens
toward or away from the camera. Take care not to pull the lens completely away from the
camera. Obtain a sharp picture in both wide-angle and telephoto positions. When the focus is
set as desired, use the Allen wrench to tighten the three back focus hex screws.
Pan—Use a Phillips-head to loosen the panning lock screw, then rotate the camera to obtain the
desired image, then tighten the panning lock screw.
Tilt—Loosen the two tilt lock screws, adjust the lens to obtain the desired image, then tighten
the screws.
Caution Do not manually adjust the focus or zoom for the IP camera. Attempting to manually do so may damage
the IP camera lens. Instead, use the Focus/Zoom window in the configuration software to remotely set
the focus and zoom for the IP camera.
Step 15 Replace the privacy shield by squeezing it to fit inside the four tabs on the camera unit (see Figure 2-6).
Make sure to adjust the privacy shield inside the dome and trim ring assembly so that it does not block
the lens from capturing video.