Filter
Top Products
8-36
User Guide for Cisco Secure Access Control System 5.3
OL-24201-01
Chapter 8 Managing Users and Identity Stores
Managing External Identity Stores
Figure 8-1 LDAP Interface Configuration in NAC Profiler
Step 5 Click Update Server.
Step 6 Click the Configuration tab and click Apply Changes.
The Update NAC Profiler Modules page appears.
Step 7 Click Update Modules to enable LDAP to be used by ACS.
You must enable the endpoint profiles that you want to authenticate against the Cisco NAC Profiler. For
information on how to do this, see Configuring Endpoint Profiles in NAC Profiler for LDAP
Authentication, page 8-36.
For proper Active Response Events you need to configure Active Response Delay time from your Cisco
NAC Profiler UI. For this, choose Configuration > NAC Profiler Modules > Configure Server >
Advanced Options > Active Response Delay.
Configuring Endpoint Profiles in NAC Profiler for LDAP Authentication
For the non-802.1X endpoints that you want to successfully authenticate, you must enable the
corresponding endpoint profiles in NAC Profiler for LDAP authentication.
Note If the profile is not enabled for LDAP, the endpoints in the profile will not be authenticated by the Cisco
NAC Profiler.
To enable the endpoint profiles for LDAP authentication:
Step 1 Log into your NAC Profiler.