Filter
Top Products
2-17
Cisco IPICS Server Installation Guide
OL-8155-01
Chapter 2 Installing the Cisco IPICS Server Software
Installing the Cisco Linux Operating System
Step 10 You must now configure the Ethernet port in your server that you will use for
Cisco IPICS. To configure the port, follow these steps:
a. Open a terminal window to enter commands. To do so, open the Red Hat
menu on the Cisco Linux desktop by clicking the Red Hat icon.
b. Choose System Tools > Network Device Control. See Figure 2-10 for an
example of the menu.
Figure 2-10 Using the Red Hat Menu
The Network Device Control window displays at least one active port. See
Figure 2-11 for an example of the window.
Note Your server may have more than one Ethernet port. If so, choose eth0.
Also, ensure that your Ethernet cable is plugged into NIC1 and not
NIC2.