Cisco Systems OL-8155-01 Security Camera User Manual


 
Chapter 2 Installing the Cisco IPICS Server Software
Installing Cisco IPICS Server Software
2-24
Cisco IPICS Server Installation Guide
OL-8155-01
Step 14 To verify network connectivity, follow these steps:
a. To open a terminal window, click the Red Hat menu and choose System
Tools > Terminal
b. To ping another server on the network, enter the following command:
ping <destination IP address>
where destination IP address represents the default gateway address, or an IP
address of another server on the network.
If the ping is not successful, troubleshoot the network connectivity with your
network administrator.
Step 15 To locate the hardware MAC address so that you can obtain your Cisco IPICS
license, follow these steps:
a. To view the MAC address for your hardware, enter the following command:
[root] #ifconfig -a
Information displays about the network interface cards.
b. Locate the eth0 heading and note the HWaddr field. This is the MAC address
for the server. Note this information so that you can use it to obtain your
license for Cisco IPICS. For more information, see the “Obtaining Your
License File” section on page 2-49.
c. To close the terminal window, click X.
The Cisco Linux operating system installation is now complete. You can continue
with the installation of the Cisco IPICS server software. If you do not want to
install Cisco IPICS immediately, you can resume the installation at a later time.
To install the Cisco IPICS server software, see the “Installing Cisco IPICS Server
Software” section on page 2-24.
Installing Cisco IPICS Server Software
To install the Cisco IPICS server, you must have successfully completed the
Cisco Linux operating system installation. For more information on installing
Cisco Linux, see the “Installing the Cisco Linux Operating System” section on
page 2-3.