Filter
Top Products
2-13
Cisco ONS 15600 Reference Manual, R7.2
Chapter 2 Card Reference
2.5.3 OC48/STM16 SR/SH 16 Port 1310 Card-Level Indicators
2.5.3 OC48/STM16 SR/SH 16 Port 1310 Card-Level Indicators
Table 2-10 describes the functions of the card-level LEDs on the OC48/STM16 SR/SH 16 Port 1310
card.
2.5.4 OC48/STM16 SR/SH 16 Port 1310 Network-Level Indicators
Table 2-11 describes the functions of the network-level LEDs on the OC48/STM16 SR/SH 16 Port 1310
card.
2.5.5 OC48/STM16 SR/SH 16 Port 1310 Card OGI Connector Pinout
Table 2-12 lists the OC48/STM16 SR/SH card OGI connector pinouts.
Table 2-10 OC48/STM16 SR/SH 16 Port 1310 Card-Level Indicators
Indicator Color Description
STAT LED
Red Indicates a hardware fault; this LED is off during normal operation.
Replace the card if the STAT LED persists. During diagnostics, the LED
flashes quickly during initialization and slowly during configuration
synchronization.
SRV LED
Green The service mode of the card. Green indicates that the card is in use,
amber indicates that the card is out of service, and off indicates that the
card is either booting or has no power applied.
LASER ON
Green The green LASER ON LED indicates that at least one of the card’s
lasers is active.
Table 2-11 OC48/STM16 SR/SH 16 Port 1310 Network-Level Indicators
Indicator Color Description
SD LED
Blue The blue SD LED indicates a SD or condition such as a low signal level
on at least one of the card’s ports.
SF LED
Red The red SF LED indicates a signal failure or condition such as LOS,
LOF, or high bit error rate (BER) on at least one of the card’s ports. The
red SF LED also turns on when the transmit and receive fibers are
incorrectly connected. When the fibers are properly connected, the LED
turns off.
Table 2-12 OC48/STM16 SR/SH 16 Port 1310 Card OGI Connector Pinout
Connector OGI Pin and Card Port
112345678
Transmit 4 Receive 4 Transmit 3 Receive 3 Transmit 2 Receive 2 Transmit 1 Receive 1
212345678
Transmit 8 Receive 8 Transmit 7 Receive 7 Transmit 6 Receive 6 Transmit 5 Receive 5