Filter
Top Products
Chapter 2 Setting Up and Configuring the Multi Services Platform
Mounting the Multi Services Platform in a Rack
2-6
Cisco Video Surveillance Manager Getting Started Guide, Release 4.2/6.2
OL-19733-01
• Consider the connection of equipment to the power supply circuitry and the
effect that possible overloading of circuits may have on overcurrent
protection and power supply wiring. Consider equipment nameplate ratings
when addressing this issue.
• Maintain a reliable ground. The rack itself should be grounded. Pay particular
to power supply connections other than direct connections to the branch
circuit (for example, power strips).
Rack Mounting
To install the Multi Services Platform in a rack, perform the following procedure.
You will need a medium-size Phillips-head screwdriver to secure the rails to the
Multi Services Platform chassis and to the rack.
Note • There are a variety of racks available. The procedure for your rack may be
slightly different than the following instructions. See the installation
instructions for your rack for additional information.
• The figures in these sections illustrate the 4 RU model. The procedures are
similar for 1 RU and 2
RU models.
.
Procedure
Step 1 Attach the inner rack rails to the Multi Services Platform.
There are two inner rack rails. One attaches to each side of the Multi Services
Platform. To attach these rails, see
Figure 2-1 and perform the actions that follow.