Filter
Top Products
After wiping once left to right and then once more right to left, fl ip
the SensorWand over and use the dry end (Side B) to wipe any extra
SensorSolution that may have accumulated on your sensor. Use the
same wiping technique that you used with the wet end. (see diagram)
Caution: Be sure to only wipe your sensor as directed in these instructions; over wiping
can cause damage and reapply dust accumulated on the wand during the fi rst wipe.
Step 6: Re-inspect with SensorScope
Re-inspect your sensor with the SensorScope to make sure you did not
miss anything. If you still see contaminants on your sensor, repeat step 5
using a new SensorWand.
Step 7: Exit sensor cleaning
When you are fi nished be sure to remove all cleaning objects out of
the camera chamber and power off the camera to exit sensor cleaning
mode.
Congratulations.
You now have a clean sensor and are ready to take crystal clear
photographs.
11