Filter
Top Products
EPSON PhotoPC 500
Consumption
Approximately 100 milliwatt at power-on
Approximately 4 W during image
processing
Battery
life
Maximum 12 W during flash discharge
Approximately 300 pictures (high
resolution) can be taken before the
batteries run out. (Using new alkaline
batteries, 150 flashed and 150
non-flashed pictures, without the
EPSON PhotoPix LCD monitor attached).
Batteries
Replace all four PhotoPC
TM
500 batteries with any of the
following:
0
Single-use AA alkaline batteries*
Cl
Single-use AA lithium batteries (longest battery life)
Cl
Rechargeable AA Ni-Cad batteries
0
Rechargeable AA Ni-MI-I batteries
*
If you have the PhotoPix LCD monitor, rechargeable or
lithium batteries are recommended.
Caution
To avoid the
&anger
qfjire
OY
explosion, do not mix different types
ofbatteries. Do not allow the battery contacts to touch metal objects
such as coins
OY
keys, which could short out the battery’s circuits.
Note the following when handling batteries:
Q
Do not use manganese batteries.
0
Replace all four batteries at the same time.
0
Do not drop, puncture, disassemble, or mutilate batteries.
Do not get them wet or expose them to fire.
Cl
When the camera is not used for long periods of time,
remove the batteries and store them at a low temperature
in a dry location.
0
Dispose of used batteries according to the battery
manufacturer’s instructions and in compliance with all
applicable laws. Contact your local government agency
for information about battery recycling and disposal.
Q
If you use rechargeable Ni-Cad batteries, replace them
with four fully-charged batteries. If your batteries run out
faster after you recharge them a number of times, make
sure you discharge them completely before recharging.
EPSON PhotoPC 500 - 2
10/96
Checking the Battery Icon
Before you take pictures, check the battery icon on the
control panel. The icon shows how much battery power you
have left, in the following stages:
Full battery power (or AC adapter in use)
@Em
Battery power is decreasing
t0
irih
Ir
Battery power is low
n
Battery power is almost out
;lzg
Change batteries
Installing Batteries
Follow these steps to install batteries:
Make sure the camera is off, then locate the battery cover
on the bottom of the camera.
Using your fingernail or a small screwdriver, slide the
battery cover lock down in the
die&ion
of the arrow and
hold it in that position while pulling the battery cover
door open.
Insert all four batteries into the compartment, positioning
them as shown.
4.
Close the battery cover, making sure that it snaps in place.
Digital Camera