Filter
Top Products
5-7
A
B
5
2 Line up the arrow on the cable connector with the port
icon on your Macintosh. Then insert the connector.
.
3 Open the connector cover on the side of the camera, as
shown on page 5-5.
4 Line up the arrow/flat side of the cable connector with
the mark on the camera’s serial port (as shown on
page 5-6). Then insert the connector.
5 Turn on the camera and your Macintosh system.
On a PowerPC
™
or G3 Macintosh (or a Windows PC with a
high-speed serial board), you may be able to transfer your
pictures at a rate of 230.4KB per second. If your camera
software doesn’t set this speed automatically, you can set it
manually. See pages 6-6 to 6-8 in your User’s Guide.
Transferring Photos With Image Expert
PhotoPC 750Z provides several different ways to transfer
your pictures from the camera to your computer. The
simplest method is to use the Image Expert software that
came with your PhotoPC 750Z. This lets you view small
thumbnail images of your pictures, and then quickly transfer
them to an album (folder) on your hard disk drive.
If you haven’t installed your software, do it now, following
the instructions on page 2-1. Make sure the camera is turned
on and connected to your computer.
Macintosh
cable
GetStart.book Page 7 Tuesday, March 2, 1999 5:13 PM