Filter
Top Products
PRELIMINARY
SECTION 5
Handling Instructions
5.1 Electrostatic Discharge
The Fairchild Imaging Osprey camera uses TDI technology in a CCD base, and as
all such devices, has some limited inherent susceptibility to electrostatic discharge
(ESD).
All reasonable and customary design steps have been taken to provide ESD
protection circuitry.
Electrostatic charge placed at the sensor could cause charging of the chip which in
some situations might not be readily dissipated and minor impact on performance
might be temporarily experienced. Therefore, do not insert your finger or any other
object into the lens mount barrel.
5.2 Preventing ESD Damage
Please be certain to ground yourself prior to handing the camera.
Ensure that your working environment is grounded, including conductive floor mats.
Do not touch the window of the imager.
5.3 Protecting Against Dust, Oil and Scratches
Be certain to avoid dust buildup on the sensor window, where it could block the
optical path.
By not touching the surface of the sensor, you avoid introducing oil and avoid
scratching the sensor window. Again, you should not insert anything into the lens
mount barrel.
5.4 Cleaning the Sensor Window
Use only clean dry air to blow off particulate matter on the sensor window
If cleaning of the sensor window is required, use lens wiping cloth with a small
amount of eyeglass cleaning fluid. Do not use solvent as it may smear the sensor
window.
Fairchild Imaging • CAM/CCD-2KLV.TDI & CAM/CCD-4KLV.TDI Line Scan Camera User’s Manual • Rev 073004 • 31 of 38