Harrington Hoists ER Digital Photo Keychain User Manual


 
GENERAL USE
EDOC0157
Page 1 of 2 Rev. 1 4/12/2000
HOISTS AND CRANES
OWNER'S MANUAL CORRECTION
"Electric Chain Hoist ER and NER Series"
1/8 Ton through 5 Ton Capacities
Manual Effective: December 6, 1999 and before
The following paragraphs, tables and figures replace in their entirety the corresponding
figures in the 1/8 to 5 Ton "Electric Chain Hoist ER and NER Series" Owner's Manual:
3.2.2 When the hoist is used without a chain container, the free end of the chain is attached to the hoist body
as shown in Figure 3-4. Connect the no load end of the chain to Chain Guide A with the End Wire or
End Suspender provided. For 5 Ton hoists, connect the no load end of the chain directly to Chain
Guide A if Chain Guide A is notched to accept the chain. Make sure the chain remains free of twists
and the chain Stopper is installed on the correct link. Refer to Table 3-2 for proper placement of
Stopper.
Figure 3-2 Chain Component Arrangement for Hoists with Upper Limit Switch Only.
Figure 3-3 Chain Component Arrangement for Hoists with Optional Upper and Lower Limit Switch.