Filter
Top Products
/RDGLQJWKH
0XOWL SXUSRVH
7UD\
406785%23ULQW6\VW HP2SHUDWLRQ
The surface (print face) of the labels must be made of normal
paper with a matte-finish, similar to copy paper.
The label backing must be able to withstand the heat generated
by the fixing assembly (190
°
C/374
°
F).
Ensure that the label backing is not made of easily removable
coated paper.
Avoid using labels with exposed adhesive; it may stick to the toner
cartridge or the fixing roller, causing labels to peel off and printer
jams to occur.
Label data should be formatted within your application. Try print-
ing your data on a plain sheet of media first to check placement.
This reduces the number of label sheets you use.
Before printing labels, disable the duplexer if it is installed and
check the manual feed guides to make sure they’re not too tight
and buckling the labels. Also, make sure label size and type meet
specifications listed in appendix B, “Technical Specifications,” of
your
Reference
guide. If labels curl excessively, use the face-up
output bin at the rear of the printer.
Load the labels lengthwise (long edge first), face up, and with the
top of the page toward the rear of the printer.