Hitachi DZ-GX3100A Camcorder User Manual


 
English
22
REMOVING BATTERY FROM REMOTE CONTROL
1 While pushing the battery holder, slide the
battery out.
Warning:
KEEP THE BATTERY AWAY FROM CHILDREN AND
PETS.
IF SWALLOWED, CONSULT A PHYSICIAN
IMMEDIATELY FOR EMERGENCY TREATMENT.
BATTERY MAY EXPLODE IF NOT HANDLED
PROPERLY. DO NOT RECHARGE, DISASSEMBLE
OR DISPOSE OF IN FIRE.
Note
:
Replace the battery with a Hitachi Maxell, Sony,
Panasonic, Sanyo, Toshiba CR2032, or Duracell
DL2032. Use of another battery may present a risk of
fire or explosion.
Dispose of battery safely in accordance with local
laws. Do not dispose of in fire.
Do not short circuit the battery.
Do not hold the battery with the metallic tweezers.
Keep the battery in a dark, cool, dry place.
The remote control (DZ-RM4W) and lithium battery
(CR2032) are supplied only with the DZ-GX3300A/
GX3200A.
Using remote Control
Point the remote control to the infrared receiver on the DVD video camera/recorder. The remote
controllable distance is up to 16 feet (5 m).
Note:
When using the remote control, make sure that the
infrared receiver on DVD video camera/recorder is not
exposed to direct sunlight or any intense light. If the
infrared receiver is subject to light stronger than the
infrared light from remote control, the DVD video
camera/recorder cannot be operated by remote
control.
If there is an obstacle between the remote control and
infrared receiver on DVD video camera/recorder,
remote control may not be possible.
The DVD video camera/recorder uses the “VCR2”
remote control code of Hitachi VCRs. If you use a
Hitachi VCR, etc. with remote control code set to
“VCR2”, a VCR placed near the DVD video camera/
recorder will also be operated by the remote control:
To prevent this, change the remote control code of the
VCR.
The remote control (DZ-RM4W) and lithium battery
(CR2032) are supplied only with the DZ-GX3300A/
GX3200A.