Filter
Top Products
9
10
11
T
e
s
t
O
f
f
O
n
O
n
w
/
L
i
t
e
TT
L
F
u
l
l
F
uel
Gu
a
g
e
R
ea
d
y
L
i
g
h
t
3
2
1
-
2
-
3
-
4
-
1
D
S
DS
SUBSTROBE
160
OOppttiioonnaall AAcccceessssoorriieess ((ccoonntt..))
SSuubbssttrroobbee DDSS116600
The Substrobe DS160 covers
the equivalent of an 18mm
lens or 100 degrees
w/diffuser installed. It is the
ideal choice when using
accessory wide angle lenses
greater than 28mm. It also
features a 1.5 second recycle
time and 225 flashes per full
charge.
i
k
e
l
i
t
e
S
U
B
S
T
R
O
B
E
D
S
51
ikelite
Substrobe
DS51
SSuubbssttrroobbee DDSS5511
The Substrobe DS51 covers the equivalent of a 28mm lens. It is the
ideal choice when using only the camera lens with no accessory
wide angle lenses attached.
Substrobe
DS160
SSAA--110000 BBaallll//SSoocckkeett AArrmm
The SA-100 system #4086.61
with its 1" diameter ball is ideal
underwater. The #9571.3
extended stem mount allows
easy attachment of the
EV-controller or flashlight
mount, and drops right into
the release handle. Aim does
not change when changing the
aim of the strobe. The arm
system allows easy strobe
placement from macro
close-up to wide angle without
changing aim of the Sensor.
The complete system removes
with a push of the handle
button.
SA-100 Ball/Socket
Arm #4086.61
#9571.3 Extended
Stem Mount (included
with SA-100
Ball/Socket arm)
D
D
i
i
f
f
f
f
u
u
s
s
e
e
r
r
The diffuser should be installed when using the camera’s built
in flash. When shooting with the camera’s built-in flash at
approximately 2 feet (0.6 m) or less, the lens port on the
housing may block a portion of the light from the camera’s
built-in flash, creating a shadow in the lower area of the photo.
If this occurs, zoom the lens slightly to eliminate the shadow.
(You can test this above water)
DDeefflleeccttoorr
The deflector should be installed when using an external strobe
such as the DS51 or DS160 Substrobe with an EV Controller. The
deflector will redirect the camera’s flash to the EV Controller
w
hich controls the external DS strobe’s output.
LLeennss PPoorrtt aanndd AAcccceessssoorryy LLeennsseess
Treat the glass in the lens port as a camera lens. After use, rinse
and gently dry the lens port to avoid water spotting. To clean,
use a mild soap solution or lens cleaner.
Do not use alcohol or window cleaner on the Lens Port.
The Housing Lens Port is threaded to accept 67mm accessory
lenses. These lenses are NOT recommended for use with this
housing due to extreme vignetting
12
O
O
p
p
t
t
i
i
o
o
n
n
a
a
l
l
A
A
c
c
c
c
e
e
s
s
s
s
o
o
r
r
i
i
e
e
s
s
ikelite
DDSS DDiiggiittaall SSttrroobbeess
For the best underwater photographic results, we recommend
a
dding an external DS-digital strobe and EV-controller, connected
to the housing with a SA-100 Ball/socket arm.
Ikelite DS series Substrobes are industry favorites for their warm,
even coverage and lightning fast recycle time. Being farther from
the camera lens, the optional DS Substrobe aids in reducing the
illumination of particles in the water and helps to eliminate
backscatter.
When used in conjunction with the EV-Controller, the DS51 Mode
switch is set to the TTL setting and the EV-Controller provides ten
power settings in half-stop increments.
OOppttiioonnaall AAcccceessssoorriieess ((ccoonntt..))
EV-controller
SSttrroobbee PPaacckkaaggeess
#3944.54 Substrobe DS-51 package includes #4086.61 Arm System
(page #11) and EV Manual Controller.
#3944.91 Substrobe DS-160 package includes #4086.61 Arm
System (page #11), 1.5 hour Smart Charger, and EV Manual
Controller
connect to
DS-Substrobe
mount to
Extended
Stem Mount
(page #11)
NNoottee::
DS Strobes must be set to “TTL” to utilize the manual
power settings on the EV Manual Controller.
EEVV MMaannuuaall CCoonnttrroolllleerr
Provides 10 manual power
settings in half-stop
increments for SubStrobe
DS-50, DS-51, DS-80,
DS-125, DS-160 and
DS-200 models.
Simply point the
Controller at your camera
housing for dependable
strobe triggering by the
camera strobe.
The Controller attaches to
the strobe and mounts
near the housing on the
#9571.3 Extended Stem
Mount (Page #11).