Filter
Top Products
EN
17
51
1024
t
@
$
9
MEMORY CARD RECORDING
Basic Shooting (Snapshot)
You can use your camcorder as a digital still camera for
taking snapshots.
Perform the procedures listed below before continuing.
●Power (੬ pg. 7)
●Grip Adjustment (੬ pg. 8)
●Viewfinder Adjustment (੬ pg. 8)
●Loading A Memory Card (੬ pg. 11)
●Picture Quality/Image Size Setting (੬ pg. 11)
1 Set the VIDEO/MEMORY Switch t to “MEMORY”,
then set the Power Switch @ to “ ” or “ ” while
pressing down the Lock Button $ located on the
switch. Open the LCD monitor fully or pull out the
viewfinder fully.
2 Press SNAPSHOT 9. “PHOTO” Q appears while
the snapshot is being taken.
The image is recorded on the memory card.
•Still images are recorded in the snapshot mode with
no frame.
To Delete Unwanted Still Images . . .
..... when unwanted still images are stored in the
memory card or its memory is full, refer to
“Deleting Files” (੬ pg. 20) and delete unwanted
still images.
To Remove The Shutter Sound . . .
..... when you do not want to hear the shutter sound,
set “BEEP” to “OFF” in the Menu Screen
(੬ pg. 34). The sound is no longer heard from the
speaker.
NOTES:
● Even if “DIS” is set to “ON” (੬ pg. 33), the Stabiliser will
be disabled.
● If Snapshot recording is not possible, “PHOTO” Q blinks
when SNAPSHOT
9 is pressed.
● If Programme AE with special effects (
੬ pg. 27) is
engaged, certain modes of Programme AE with special
effects are disabled during Snapshot recording. In such a
case, the icon blinks.
● If shooting is not performed for approx. 5 minutes when
the Power Switch
@ is set to “ ” or “ ” and power is
supplied from the battery pack, the camcorder shuts off
automatically to save power. To perform shooting again,
close the LCD monitor and re-open it. When using the
viewfinder, push back it in and pull it out again.
● The Motor Drive mode (
੬ pg. 29) is disabled when the
VIDEO/MEMORY Switch
t is set to “MEMORY”.
● When a cable is connected to the S/AV connector
&, the
shutter sound is not heard from the speaker, however it is
recorded onto the tape.
● Still images taken are compliant to DCF (Design rule for
Camera File system). They do not have any compatibility
with devices which are not compliant to DCF.
Display
Shooting icon
੬ pg. 54, 55
Image Size
੬ pg. 11
Remaining number of shots
੬ pg. 54, 55
(Approximate Number of
Storable Images
੬ pg. 18)
Picture Quality
੬ pg. 11
Card icon
੬ pg. 54, 55
To Protect Valuable Files (available only for SD
Memory Card) . . .
.....slide the write/erase protection tab on the side
of the memory card in the direction of “LOCK”.
This prevents the memory card from being
recorded over. To record on this memory card,
slide the tab back to the position opposite to
“LOCK” before loading it.
Write/erase
protection tab