Filter
Top Products
EN 33
Master Page: Right
By resetting the file name, a new folder will be
made. The new files you are going to make will be
stored in the new folder. It is convenient to separate
the new files from previously made files.
1 Load a memory card. (੬ pg. 19)
2 Set the Playback Mode Switch to “MEMORY”.
3 Set the Power Switch to “P” while pressing
down the Lock Button located on the switch.
4 Open the LCD monitor fully, or pull out the
viewfinder fully.
● The still image which has been played back at
the last time is displayed.
5 Press the MENU Wheel in. The Menu Screen
appears.
6 Rotate the MENU Wheel to select “NO. RESET”,
and press it. The NO. RESET screen appears.
7 Rotate the MENU Wheel to select “EXECUTE”,
and press it. The new folder (such as
“101JVCGR”) will be made and the file made of
the next shot starts from DVC00001.
Folder and File names
Each time shooting takes place, a file name is made
using a number which is larger by one than the
largest number of the file names which are in use.
Even if you delete an image file with a number in the
middle of range, the number will not be used for a
new shot; a gap will remain in the numerical
sequence. If the file name reaches DVC09999, a
new folder (such as “101JVCGR”) will be made and
the file name will start again from DVC00001.
This camcorder is compatible with the DPOF
(Digital Print Order Format) standard in order to
support future systems such as automatic printing.
You can select one of the 2 print information settings
for images stored in the memory card: “To Print All
Still Images (One Print For Each)” or “To Print By
Selecting Still Images And Number Of Prints”.
NOTES:
● If you load a memory card already set as shown
below in a printer compatible with DPOF, it will
make prints of the selected still images
automatically.
● To print images recorded on a tape, first dub them
to a memory card. (੬ pg. 57)
To Print All Still Images (One Print For Each)
1
Load a memory card. (੬ pg. 19)
2 Set the Playback Mode Switch to “MEMORY”.
3 Set the Power Switch to “P” while pressing
down the Lock Button located on the switch.
4 Open the LCD monitor fully, or pull out the
viewfinder fully. The still image which has been
played back at the last time is displayed.
5 Press the MENU Wheel in. The Menu Screen
appears.
6 Rotate the MENU Wheel
to select “DPOF”, and
press it. The Sub Menu
appears.
7 Rotate the MENU Wheel
to select “ALL 1”, and
press it. The DPOF screen
appears.
8 Rotate the MENU Wheel
to select “EXECUTE”, and
press it. The normal
playback screen appears.
● To cancel selection,
select “RETURN”.
Resetting The File Name Setting Print Information (DPOF
Setting)
DPOF
M
E
NU
RENT
ALL 1
RESET
RETURN
CUR
DPOF
EXECUTE
ALL1?
RETURN
DIGITAL STILL CAMERA (D.S.C.) RECORDING & PLAYBACK
CONTINUED ON NEXT PAGE
GR-HD1US.book Page 33 Monday, April 14, 2003 5:21 PM