Filter
Top Products
EN 43
Master Page: Right-Heading0
FEATURES FOR RECORDING
Once the camcorder is set, the camcorder operator
can become part of the scene in a more natural way,
adding the final touch to a memorable picture.
1 Set the Power Switch to “M” while pressing down
the Lock Button located on the switch.
2 Open the LCD monitor fully, or pull out the
viewfinder fully.
● You can tilt the LCD monitor upward to 180°
so that it faces forward and view yourself while
self-recording with the viewfinder pushed
back.
3 Set “SELF-TIMER” to
“ON ”. (੬ pg. 35, 37)
4 To engage the Self-Timer
for video recording, press
the Recording Start/Stop
Button.
● After 15 seconds, the
beep sounds and video
recording starts.
To stop Self-Timer
recording, press the
Recording Start/Stop
Button again.
● The camcorder re-enters
Record-Standby mode.
OR
4 Press SNAPSHOT.
● After 15 seconds, the beep sounds and
snapshot recording starts. After that, the
camcorder re-enters Record-Standby mode.
5 To end Self-Timer recording, select “OFF” in
step 3.
NOTE:
If “BEEP” and “TALLY” are set to “OFF” (੬ pg. 38),
the beep does not sound and the tally lamp does not
light.
Self-Timer
Power Switch
SNAPSHOT Button
Lock Button
NU
L MA A
OMEL –TI SE F R FF–
NRETUR
O
N
Self-Timer indication
When the Recording Start/
Stop Button or SNAPSHOT is
pressed, the tally lamp
changes as shown:
Begins blinking
(Self-Timer starts)
Blinks quickly
(Self-Timer shooting starts
soon)
Stops blinking and stays on
(Self-Timer video recording
starts)
OR
Turns off
(Self-Timer snapshot
recording occurs)
After approx.
15 sec.
ADVANCED FEATURES
GR-HD1US.book Page 43 Monday, April 14, 2003 5:21 PM