Filter
Top Products
EN 81
Master Page: Right-Heading0
USER MAINTENANCE
1 Turn off the camcorder.
2 Loosen the grip strap.
3 Slide and hold OPEN/EJECT in the direction of
the arrow, then pull the cassette holder cover
open until it locks. The cassette holder opens
automatically. Remove the cassette.
4 Press “PUSH HERE” to close the cassette holder.
● Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely
before closing the cassette holder cover.
5 Slide BATT.RELEASE 1 and remove the battery
pack 2 3.
1 To clean the exterior, wipe gently with a soft
cloth.
Put the cloth in diluted mild soap and wring it
well to wipe off heavy dirt. Then wipe again with
a dry cloth.
2 Press PUSH OPEN and open the LCD monitor.
Wipe gently with a soft cloth. Be careful not to
damage the monitor. Close the LCD monitor.
3 To clean the lens, blow it with a blower brush,
then wipe gently with lens cleaning paper.
4 To clean the viewfinder, raise the viewfinder to
the vertical position.
5 Open the viewfinder cleaning hatch in the
direction of the arrow A.
Insert a lens blower or soft cloth into the gap at
the bottom of the viewfinder and clean the
interior of the viewfinder with it B.
6 Close the hatch. Tilt the viewfinder back to the
horizontal position and push it back in.
NOTES:
● Avoid using strong cleaning agents such as
benzine or alcohol.
● Cleaning should be done only after the battery
pack has been removed or other power units have
been disconnected.
● Mould may form if the lens is left dirty.
● When using a cleaner or chemically treated cloth
refer to the cautions of each product.
After Use
BATT.RELEASE Switch
Remove.
Cassette holder
cover
Cassette holder
PUSH HERE
OPEN/EJECT Switch
Cleaning The Camcorder
Hatch
Lens blower
REFERENCES
GR-HD1US.book Page 81 Monday, April 14, 2003 5:21 PM