Filter
Top Products
EN 29
C:
Connection to a TV or VCR equipped
with an S-VIDEO IN and/or A/V
input (RCA type) connectors
NOTE:
Use the provided A/V cable and S-VIDEO cable.
CONNECT CAMCORDER TO
TV/VCR
1
As shown in the illustration at left, connect the
S-VIDEO cable and/or the A/V cable to the S-
VIDEO (or the VIDEO) and AUDIO connectors
on the camcorder and to those on the VCR or
TV.
SUPPLY POWER
2
Turn on the camcorder, VCR and TV.
SELECT MODE
3
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
D: Connection to a TV with NO A/V
Input Connectors (Playback ONLY)
NOTE:
Use the optional RF-V5E RF unit.
Connect it to the camcorder's VIDEO, AUDIO and
RF DC OUT connectors.
* Refer to the RF-V5E instruction manual for the
connection procedure.
NOTES:
●
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery
pack.
●
To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder's Power switch to “CAMERA”, then set
your TV to the appropriate input mode.
●
If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to
the TV as interference will occur in the camcorder
playback picture.
A: Connection to a TV or VCR equipped
with a SCART connector compatible
only with regular video signals
NOTE:
Use the provided A/V cable and cable adapter.
CONNECT CAMCORDER TO
TV/VCR
1
As shown in the illustration at left, connect the
A/V cable to the AUDIO and VIDEO connectors
on the camcorder and to those on the cable
adapter, and then connect the cable adpter to
the SCART connector on the VCR or TV.
SET “Y/C”/“CVBS” SWITCH
2
Set the “Y/C”/“CVBS” video out select switch
on the cable adapter to “CVBS”.
SUPPLY POWER
3
Turn on the camcorder, VCR and TV.
SELECT MODE
4
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
B: Connection to a TV or VCR
equipped with a SCART connector
compatible with Y/C signals
NOTE:
Use the Provided S-VIDEO cable, A/V cable and
cable adapter.
CONNECT CAMCORDER TO
TV/VCR
1
As shown in the illustration at left, connect the
S-VIDEO cable and the A/V cable to the S-
VIDEO and AUDIO connectors on the
camcorder and to those on the cable adapter,
and then connect the cable adapter to the
SCART connector on the VCR or TV.
SET “Y/C”/“CVBS” SWITCH
2
Set the “Y/C”/“CVBS” video out select switch
on the cable adapter to “Y/C”.
SUPPLY POWER
3
Turn on the camcorder, VCR and TV.
SELECT MODE
4
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.