Filter
Top Products
70 EN
TROUBLESHOOTING
(Cont.)
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
25.
•This is a result of
exceedingly high contrast,
and is not a malfunction.
26.
•If Audio Dubbing or Insert
Editing have been performed
repeatedly on the same
portion of the tape,
disturbance to the sound
and picture may result.
27.
•“DISPLAY” is set to “OFF” in
the Date/Time Menu.
•Interface shooting is
performed.
28.
•“ON SCREEN” is set to
“OFF” in the Date/Time
Menu.
29.
•You have made the
indicators disappear.
30.
•In places subject to low
temperature, images
become dark due to the
characteristics of the LCD
monitor. When this
happens, the displayed
colours differ from those that
are actually recorded. This is
not a defect of the
camcorder.
•When the LCD monitor's
fluorescent light reaches the
end of its service life, images
on the LCD monitor become
dark. Consult your nearest
JVC dealer.
31.
•The light used to illuminate
the LCD monitor causes it to
become hot.
32.
•This may occur when the
surface or the edge of the
LCD monitor is pressed.
33.
The speaker volume is too
great.
34.
————
25.
————
26.
•Use a new, or infrequently
used, tape for Audio
Dubbing and Insert Editing
(੬ pg. 65, 66).
27.
•Set “DISPLAY” to “ON” in
the Date/Time Menu
(੬pg. 11).
•During interface shooting,
the date/time does not
appear (੬ pg. 23).
•Press the IND. ON/OFF
button for longer than 1
second to make the indica-
tors appear (੬ pg. 22).
28.
•Set “ON SCREEN” to “ON”
in the Date/Time Menu
(੬ pg. 33).
•Press the IND. ON/OFF
button for longer than 1
second to make the indica-
tors appear (੬ pg. 22).
29.
•Press the IND. ON/OFF
button for longer than 1
second to make the indica-
tors appear (੬ pg. 22).
30.
•Adjust the brightness and
angle of the LCD monitor
(੬ pg. 22, 23).
31.
•Close the LCD monitor to
turn it off or set the Power
Dial to “OFF”, and let the
unit cool down (੬ pg. 19).
32.
————
33.
•Turn the speaker volume
down (੬ pg. 49).
34.
•Wipe them gently with soft
cloth. Wiping strongly can
cause damage.
25.
When shooting a subject
illuminated by bright
light, vertical lines appear.
26.
There are disturbances in
audio and video.
27.
During recording, the
date/time does not
appear.
28.
The indicators and
messages do not appear
on screen.
29.
The indicators do not
appear on the LCD
monitor or in the
viewfinder.
30.
Images on the LCD
monitor appear dark or
whitish.
31.
The rear of the LCD
monitor is hot.
32.
The indicators and the
image colour on the LCD
monitor are not clear.
33.
Images on the LCD
monitor are jittery.
34.
The LCD monitor and the
lens have become dirty
(ex. fingerprints).