Filter
Top Products
EN 37
Exposure Control
If the subject is predominantly white, black, red, etc., the resulting picture may be underexposed (too dark).
In such a case, it is necessary to use the exposure control to restore the picture to a more realistic image.
With this camera, you can make this adjustment by up to +/–2 iris steps in units of 0.5EV (exposure value).
1
Turn the Power dial to “M”or “V”.
•Hold the Lock button down while turning the
Power dial.
2
Press the Exposure control button (+/–), and
then press the w e button within 3 seconds.
•Press the e button to cycle through the
following modes:
–2 → –1.5 → –1.0 → –0.5 → 0 → +0.5 →
+1.0 → +1.5 → +2.0
(Darker to brighter)
•Press the w button to cycle through the
modes in the opposite direction.
3
Point the lens at the subject and half-press the
Shutter button.
•The camera will continue to focus on the
subject while the button is half-pressed.
The shoot standby lamp (green) flashes.
•To display the image on the LCD screen
while shooting, press the DSP button.
4
Press the Shutter button all the way to take
the picture.
2
1
OFF
M
4
SET
V
3,4
(–2EV) (+2EV)