Filter
Top Products
35
Attaching the Tripod Base
(Provided only for U model)
Use the provided tripod base to place the camera on a tri-
pod. (U model only)
1. Attach the tripod base on the tripod by using the hole that
balances this device most optimally.
2. While pushing the safety lever, pull the lock lever toward
the front until the front mount clip clicks into place.
3. Place this device on the tripod base by aligning the rear
base mount of this device with the pin on the tripod base.
4. Hold the camera on the top and slide forward so that the
base mount of the camera is locked by the front mount
clip of this device as it clicks into place.
CAUTION
• The front base mount may be locked while the pin of the
tripod base is not inserted into the hole on the rear base
mount of this device. Therefore, after mounting, make
sure that these parts are engaged properly.
• When moving this device mounted on a tripod, any
impact or vibration should be avoided as this may cause
this device to become detached and to drop from the tri-
pod.
Be sure to remove this device from the tripod before
transporting it.
1. Tripod mounting holes
Front mount clip
2. Safety lever
3. Pin
2.
Lock lever
4. Front base mount
3. Rear base mount
MACRO
USER 3USER 2USER 1
STATUS
MENU
2
1
ND FILTER
REC
OFF
ON
POWER
WHT.BAL
AUTO
AUDIO
LEVEL
AUTO
CH-1 CH-2
VF BRIGHT
4.
e_hd250.book Page 35 Tuesday, October 24, 2006 3:11 PM