Filter
Top Products
107
* When status indications are magnified, warnings are not displayed on the LCD monitor.
X See “Magnified Status Indications on the LCD Monitor” on page 29.
Display Status Action
CHANGE PB TAPE
FORMAT*
Image format which is different from the one set in the PB
TAPE item on the VIDEO FORMAT[2/2] menu screen is be-
ing played back.
Check the setting for the PB TAPE item.
X See page 79.
LOW VOLTAGE* Battery is low. Charge the battery pack or replace it.
TAPE NEAR END* There are less than 3 minutes remaining on the tape (flash-
es only when recording).
To continue shooting, find a new tape or replace the tape.
TAPE END* Displayed when the tape ends. Replace the tape.
CHANGE 1394
SWITCH*
Recording or playback video format and the IEEE1394 set-
ting is different when connected to the IEEE1394 port.
Set the IEEE1394 switch correctly, turn the power off and
then on again.
SWITCH TO VTR
MODE*
Tried to use the FF or REW button in camera mode. Press the CAM/VTR button to set VTR mode.
HEAD CLEANING
REQUIRED
Displayed when the video head is dirty. (Head clogging was
detected during an edit search in shooting mode as well as
during playback and displayed.)
Clean with a special head cleaning tape.
X See page 7.
CLEANING TAPE! Displayed when a head cleaning tape is inserted. The display disappears when the head cleaning tape is re-
moved.
COPY GUARD!* Tried to play back a copyguarded tape. Cannot play back a copyguarded tape.
FAN MOTOR HOUR Over the prescribed fan motor usage time. Please contact your local dealer or JVC.
PUSH CASSETTE
COVER*
The videocassette cover is not firmly shut. Lightly push the top center of the videocassette cover.
CHANGE THE SYS-
TEM*
Displayed when you attempt to change FRAME RATE item
in the VIDEO FORMAT menu screen.
When the FRAME RATE item setting is changed, the frame
rate system for this device is changed. Check the frame
rate to use before changing the setting.
X See pages 54 and 77.
e_hd250.book Page 107 Tuesday, October 24, 2006 3:11 PM