Filter
Top Products
67
Dubbing with AV Devices
By connecting the video signal output terminal and the
AUDIO OUTPUT terminal on GY-HD250/GY-HD251 to an AV
device, analog signal dubbing is possible.
1. Connect the cables.
2. Turn both devices on.
3. Set this device to VTR mode.
Press the CAM/VTR button. The VTR indicator lights.
4. Set the video output.
Set the VIDEO FORMAT menu screen. X See page 77.
• HDV PB OUTPUT item:
Set the video format to be output from the video output
terminal during tape playback.
• PB TAPE item:
Select whether to automatically detect the playback tape
video format or play back only a particular format.
Normally, use the “AUTO” setting.
• OUTPUT TERM. [DV] item:
Set component, RGB or Y/C signals for the output image
signals of the [Y/P
B/PR] terminal. (Only for DV format)
5. Set the audio output. X Seepage63.
Set the AUDIO menu screen. X See page 87.
• PB AUDIO CH [DV] item:
Set the audio channel to be output.
6. Insert the videocassettes.
7. Press the PLAY/STILL button on the GY-HD250/GY-
HD251 to start playback.
8. Start recording on the recording unit.
For details, see the instructions to the unit used for
recording.
9. When dubbing is completed.
Stop recording on the recording unit, and then press the
STOP button on the GY-HD250/GY-HD251 to stop play-
back.
IEEE 1394
CH2-AUDIO OUT-CH1 VIDEO
Signal flow
Recording unit
AUDIO
OUTPUT
connector
Signal flow
Composite cable
or
Component cable
VIDEO FORMAT menu screen
GY-HD250/GY-HD251 : Insert the recorded videocas-
sette.
Recording unit : Insert the videocassette to be
dubbed to.
AUDIO menu screen
e_hd250.book Page 67 Tuesday, October 24, 2006 3:11 PM