JVC GY-HM700U Camera Accessories User Manual


 
12
Introduction
Side Terminal
A [HD/SD-SDI] HD/SD-SDI Output Terminal (BNC)
(A Page 111)
B
[Y/VIDEO] Y/Composite Video Signal Output Terminal
(BNC) (
A
Page 111)
C
[PB] PB Video Signal Output Terminal (BNC)
(
A
Page 111)
D
[PR] PR Video Signal Output Terminal (BNC)
(
A
Page 111)
E
[REMOTE] Remote Terminal (
A
Page 116)
F
[DC INPUT] DC Input Terminal (
A
Page 21)
Input terminal for DC 12 V power supply. Connects with an
AC adapter.
G
[AUDIO OUTPUT] Audio Output Terminal (RCA)
Output terminal for audio signals.
Input audio signals are output during Camera mode.
Playback audio signals are output during Media mode.
Audio from input audio signals is output during HD/DV signal
(IEEE1394) input.
Memo :
Alarm tone is not output.
H
[HD/DV] IEEE1394 Terminal Mode Switch
(
A
Page 112)
I
[INT/EXT] IEEE1394 Interface Terminal Switch
(
A
Page 112)
For selecting a valid IEEE1394 interface terminal.
J
Shoulder Pad Slide Button
For adjusting the shoulder pad position. Press this button to
adjust the shoulder pad K position to the front or back.
K
Shoulder Pad
L
[USB] USB Terminal (
A
Page 115)
M
[IEEE1394] IEEE1394 Terminal (4-pin)
For connecting digital video equipment with IEEE1394
terminal using an IEEE1394 cable (sold separately).
To enable this terminal, set the [INT/EXT] IEEE1394 terminal
switch I to [EXT].
(
A
Page 112 [IEEE1394 Connection])
(
A
Page 114 [Stream Transmission to a Non-linear Editing System])
Note :
When connecting IEEE1394 cables, check that the
connectors are facing the right direction before you insert.
Memo :
Put on the covers when the connectors are not in use.
Names of Parts (continued)
[EXT]
Enables IEEE1394 signals from the [IEEE1394]
terminal M.
[INT]
Enables the Accessory Connector B at the rear
of the camera recorder. (A Page 13)
A
C
E
F
G
D
B
HI
J
K
L
M