JVC GZ-HM400 Camcorder User Manual


 
82
EN
Menus Settings: [ ] = Factory-preset
Y BASIC SETTINGS
Select [BASIC SETTINGS], then select sub-menus.
@ CONT. SHOOTING SPEED
Sets the interval for continuous
shooting.
With each setting, continuous recording is performed at the
following speed:
HIGH SPEED: 6 frames in 0.4 seconds at 15 frames per
second. ( )
MEDIUM SPEED: 6 frames in 0.9 seconds at 7 frames per
second. ( )
[LOW SPEED]: 2 frames per second while
SNAPSHOT is
pressed. ( )
NOTE
The continuous shooting speed will drop if this function is used
repeatedly.
[ DEMO MODE
Introduces special features of
the camcorder when there is no
operation for about 3 minutes during
recording mode.
OFF: Deactivates the function.
[ON]: Activates the function.
NOTE
The demonstration only works when the AC adapter is
connected, not with the battery pack.
If an SD card is in the camcorder, demonstration will not take
place even if this mode is set to [ON].
(
AUTO POWER OFF
If the camcorder is not operated for
5 minutes while the power is on,
it turns itself off automatically to
conserve power.
OFF: Disables the function.
[ON]: Activates the function.
To turn the camcorder on again, close the LCD monitor
and open it again when using the battery pack. When
using the AC adapter, perform any operation such as
zooming.
\ OPERATION SOUND
Turns on/off the operation sound.
OFF: Turns off the operation sound.
[ON]: The melody sounds when operations are performed.
RECORD BUTTON
Enables the recording button [REC]
on the LCD monitor.
OFF: Deactivates the function.
[ON]: Activates the function.
`
QUICK RESTART
Enables the camcorder to start
up quickly when you turn off the
camcorder and then on again within
5 minutes by closing and opening
the LCD monitor.
OFF: Deactivates the function.
[ON]: If the LCD monitor is opened again within 5 minutes,
the camcorder starts quickly. The power consumption
used for the 5 minute period after the LCD monitor is
closed is approximately 1/3 that used during recording.
This enables you to save more power than leaving the
power on.
Changing the Menu Settings (Continued)