Filter
Top Products
28
Warning Messages
To prevent operational errors, the LCD display shows one of the following warning messages when
an erroneous operation is performed.
Displayed Message
INVALID ENTRY
GAIN : LOLUX
INVALID ENTRY
FULL AUTO : ON
INVALID ENTRY
GAIN : ALC + EEI
INVALID ENTRY
GAIN : ALC
INVALID ENTRY
W.BAL : FAW
INVALID ENTRY
W.BAL : PRESET
INVALID ENTRY
W.BAL : MANUAL
INVALID ENTRY
BARS : ON
The gain is set to the Lolux mode.
The FULL AUTO button is ON.
ALC+EEI is ON.
ALC is ON
The white-balance is set to the FAW
mode.
The W.BAL button is set to PRESET.
The white balance adjustment is set to
manual mode by the AUTO/MANU button.
The BARS button is pressed.
Exit from the Lolux mode, and then
adjust the gain again.
Press the FULL AUTO button so that
the lamp in it turns off, then retry
operation.
Exit from the ALC+EEI mode, and then
retry operation.
Exit from the ALC mode, and then retry
operation.
Cancel FAW and start the white-balance
adjustment.
Auto white balance adjustment cannot
be started in this mode.
Auto white balance adjustment cannot
be started in this mode.
Press the BARS button so that the
lamp in it turns off, then retry operation.
General
Cause Check Point
Error Messages
When the LCD display shows one of the following error messages during an auto white balance
adjustment and AUTO SET mode, check “Cause” and “Check Point” below and then retry the auto
white balance adjustment. (The error message is displayed for about 5 seconds.)
Displayed Message
AUTO WHITE A (B)
ERROR: LOW LIGHT
AUTO WHITE A (B)
NG: OBJECT
AUTO WHITE A (B)
ERROR: OVER LIGHT
AUTO BLACK LENS NOT CLOSED?
AUTO BLACK ERROR!
The light intensity is insufficient.
The object is not suitable for shooting.
● The amount of incident light is too high.
● The color temperature conversion fil-
ter is not set properly.
The lens will not close for auto black-bal-
ance adjustment.
Auto black adjustment is not working
properly.
Increase the lighting (illumination) or
boost the gain with the GAIN button.
(Note that the sensitivity deteriorates
when the gain is boosted.)
Check if the object is white and change
the object if required.
● Check if a strong light source, such as
the sun, is shining into the camera ei-
ther directly or as a result of a reflec-
tion caused by the object.
● Set the color temperature conversion
filter to the correct position.
Set the camera so that the lens can be
closed.
Check the setups of the RM-HP250 and
camera again.
Cause Check Point