Filter
Top Products
WR-DVXU Marine Case
User’s Manual ENGLISH
Names of the parts
Please read before use.
This marine case is a precision instrument designed
to permit safe video recording under high water
pressure. Please pay careful attention when handling
the unit before and after use, as explained in this
user’s manual.
Each part of the marine case has been subject to
strict controls during the manufacturing process, and
the individual functions have faced stringent tests
during the assembly process. Each marine case has
also had to pass water-proof inspections using high-
pressure water testers. However, damage can some-
times occur during transport and distribution, or
during storage after purchase, so before diving
always carry out the following pre-use test to verify
safety.
Pre-use test
When using the marine case for the first time after pur-
chase, or after it has been in storage for a long time, dive
to the usage depth with only the empty marine case
(without mounting the camcorder inside), and test for
water leaks.
1
..........Marine case front lid
2
..........Buckle
3
..........Power dial
4
..........START/STOP button
5
..........Zoom lever
6
..........SNAPSHOT button
Mounting method and operating method for
each part
1. Remove the four buckles on the marine case and open
the front lid.
2. Remove the camcorder hand strap or grip strap.
3. Open the LCD monitor, then insert the camcorder into
the marine case.
4. Position so that the power
dial projection in the
marine case pushes the
lock button located on the
camcorder power dial.
5. Turn the marine case
power dial to the left to
move the camcorder
power dial to the “
A
”
position.
6. Place the included anti-
fogging silica gel in the
gap between the
camcorder and the marine
case to prevent fogging in
the marine case.
7. Before sealing the marine
case, check that there is no
sand, dirt, or other foreign
matter on the O-ring
mounted on the front lid or on the O-ring contact
surface on the main unit.
Also make sure that the inserted silica gel bag is not
pinched. If you dive with foreign matter trapped in
these areas, water will leak.
8. Check that the O-ring on the front lid is correctly
mounted in the groove, then press in the front lid.
Flip down the four buckles in the directions indicated
by the arrows in the figure on the right to seal the
marine case.
9. Press the START/STOP
button once to start
recording from the
camcorder (
1
in the figure
on the right). Press the
button again to stop
recording (
1
in the figure
on the right).
10.The zoom can be adjusted
with the zoom lever (
2
in
the figure on the right).
11. It is possible to take a snapshot using the SNAPSHOT
button (
3
in the figure on the right).
12.When you are finished
shooting, turn the power
dial to the right to switch
the camcorder power dial
to the Off position (
4
in
the figure on the right).
6
5
4
2
3
1
2
4
1
3
2
For GR-DVX
Digital Video Camera
LYT0002-0Q9A