Filter
Top Products
6 KODAK Display Manager System V4.1 User’s Guide
Introduction
Supported Hardware
The following hardware is recommended for use with the Display Manager
System.
Generic Monitor Support
The Display Manager System supports many different monitors but not all
monitors can be automatically calibrated by the system. Most high-quality
professional grade monitors can be calibrated.
The first time that you initiate an automatic calibration, you are prompted to
attach a sensor to the monitor so that the system can assess if the monitor
can be automatically calibrated.
NOTE
Before running this evaluation, set your monitor to Expert mode and turn off the
Super Bright mode if applicable.
You are then notified if the monitor can be automatically calibrated. If it cannot,
you can manually adjust your monitor using SMPTE standard procedures and
the supplied colorbars chart. For more information, see
“Manual Calibration”
on page 36.
This evaluation runs whenever you attach a monitor that was not previously
tested with the system and then initiate automatic calibration.
Supported Displays
In addition to displays that can be automatically calibrated, you can use the
Display Manager System with LCD monitors, HD/SD displays, and digital
projectors. We recommend cinema grade digital projectors.
Enable Cable (USB Cable ECC 1)
An enable cable is required to transfer data from your monitor to your
computer. This cable can be obtained through Kodak. Contact your service
representative.