Kodak 4F3882 Camera Accessories User Manual


 
KODAK Display Manager System V4.1 User’s Guide 83
Troubleshooting
Imaging Product Cannot Find LUT
If your imaging product cannot find the LUT that you created from the Viewer:
Make sure you have the proper path set. Go to Options > Setup and from
the Directories tab set the path.
Make sure your imaging product is supported by the Display Manager
System.
Refer to your imaging product user guide for directions on LUTs generated
by the Display Manager System.
My 1D LUT Does Not Match my 3D LUT
1D LUTs provide a tonescale emulation of the projected print film.
3D LUTs provide both tonescale and color emulations.
My Wide Color Gamut Encoded LUT Does Not Look
Correct
Wide Color Gamut encoded LUTs imported to the viewer will not look correct.
These LUTs are not intended for preparing an image for display on a computer
monitor.
Problem with the .ini File
When opening the Display Manager System, you may see an error message
for the .ini file if you have not yet saved any settings for the first time.
If you have saved your settings but you still get a message that there is a
problem with the .ini file:
1. Click OK.
The system opens using the factory defaults for any unknown values.
2. Reset and save your system options. See Saving and Loading Settings
on page 30.
3. If necessary, reset and save your Viewer settings. See Viewing and
Customizing Looks” on page 49.