Kodak 800 SERIES Camcorder User Manual


 
Maintenance 3-4
NovaJet 800 Series Service Manual
7. If the service station is filling with ink or very dirty it can be removed and rinsed
under warm water. To remove, pull the tab on the right side of the service station
and lift out. Wash, dry thoroughly and replace by placing the left side in first then
pushing down on the right side until the tab locks it in place.
Linear Encoder Strip Cleaning
Clean the linear encoder strip weekly or as necessary to remove any buildup of debris.
Distilled water or isopropyl alcohol may be used. You may notice that it tends to fog the
encoder strip; however, no detrimental effect has been observed in the field.
To clean the Encoder Strip:
1. Disconnect the power cord and interface cable.
2. Slightly dampen a cotton swab with distilled water and wipe along the length of the
encoder strip on both sides. Do not use denatured alcohol, MEK, acetone or
keytone substances on the encoder strip as this is known to have caused damage
to the encoder strip.
3. Reconnect the power cord and interface cable.
Figure 3-1. Encoder Strip Cleaning.