Filter
Top Products
Troubleshooting
www.kodak.com/go/support
47
In Review mode, a
blue or black
screen is displayed
instead of a
picture.
■ Transfer the picture to the computer (page 39), then format the card or
internal memory (see page 37).
CAUTION: Formatting a card deletes all pictures and videos,
including protected files.
Shutter button
does not work.
■ Turn on the camera (page 2).
■ Transfer pictures to the computer (page 39), delete pictures from the
camera (page 19), switch image storage locations (page 35), or insert
a card with available memory (page 3).
Slide show does
not run on external
video device.
■ Adjust the camera Video Out setting (NTSC or PAL, see page 37).
■ See the external device’s user’s guide.
Picture is too light. ■ Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■ Decrease Exposure Compensation (page 16).
Picture is not clear. ■ Clean the lens (page 58).
■ Make sure your camera is not in Close-up mode.
■ Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■ Press the shutter button halfway to focus and set exposure. When the
framing marks turn green, press the Shutter button completely down.
■ Place the camera on a flat, steady surface or use a tripod.
Picture is too dark. ■ Turn on the flash (page 9).
■ Move so there is no more than 11.8 ft (3.6 m) in wide angle and
6.9 ft (2.1 m) in telephoto between the camera and the subject.
■ Use Fill flash (page 9) or change your position so light is not behind
the subject.
■ Increase Exposure Compensation (page 16).
If Try one or more of the following