Filter
Top Products
Troubleshooting
www.kodak.com/go/support
31
Picture is too light.
■ Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■ Decrease Exposure Compensation (see page 22).
Picture is not clear.
■ Clean the lens (see page 38).
■ Make sure your camera is not in Close-up mode.
■ Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■ Place the camera on a flat, steady surface or use a tripod.
Picture is too dark.
■ Turn on the flash (see page 6).
■ Move so there is no more than 7.9 ft (2.4 m) between the camera and
the subject.
■ Use Fill flash (see page 6) or change your position so light is not
behind the subject.
■ Increase Exposure Compensation (see page 22).
Camera does not
recognize SD card.
■ Purchase a certified SD card.
■ Insert a card into the slot, then push to seat (see page 3).
Camera freezes up
when a card is
inserted or
removed.
■ Turn the camera off, then back on. Make sure the camera is turned off
before inserting or removing a card.
Memory card full.
■ Insert a new card (see page 3).
■ Transfer pictures to the computer (see page 27).
■ Delete pictures/videos (see page 12).
If... Try one or more of the following