Filter
Top Products
37 www.kodak.com/go/support
Doing more with your camera
Changing the flash settings
NOTE:
Flash settings are preset for each picture-taking mode. Some of the flash settings may
not be available in all Capture or SCN modes. When you change to Auto or Red-eye in
some of these modes, it becomes the default until you change it.
NOTE: For rapid setting changes, see page 43.
Flash mode Flash fires
Auto When the lighting conditions require it.
Fill Every time you take a picture, regardless of the lighting conditions. Use
when the subject is in shadow or is "backlit" (when the light is behind
the subject). In low light, hold the camera steady or use a tripod.
Redeye Once, so the subject’s eyes become accustomed to the flash, then fires
again when the picture is taken. If the lighting conditions require flash
but do not require Red-eye reduction, the flash may fire only once.
Slow
front
sync
Regardless of the shutter speed and right after the shutter fully opens.
Only useful when slower shutter speeds are used. For other slow-flash
settings, see table on page 53.
Off Never.
1
(Press
again to exit.)
Press
.
Press OK or Set.
2
to highlight an option.
3
A blinking flash icon indicates the flash
is charging. Take the picture
when the blinking stops.