Kramer Electronics T6F-23 Digital Photo Frame User Manual


  Open as PDF
of 2
 
The Kramer T6F-23 inner frame
Congratulations on purchasing your Kramer T6F-23 inner frame for the TBUS-6xl Table
Connection bus.
The T6F-23 inner frame includes:
• 2 openings for 2 power sockets
• 2 blank inserts
• 1 pass-through opening
Figure 1: T6F-23 inner frame (P/N: 80-004499)
Power Socket and Power Cord Options
Various power sockets and power cords are available to use with the T6F-23, as described in the
“TBUS Modular Power Socket Installation and Power Cord” Installation Instructions, supplied with
the power socket.
i
Each power socket comes with detailed assembly instructions.
The T-2INSERT Kit Option (80-00006699)
You can install the T-2INSERT kit (which includes 1 pass-through insert and a blank insert)
instead of a power socket.
Mounting the Inserts
i
Go to http://www.kramerelectronics.com to check for up-to-date
user manuals and the complete list of Kramer wall plates and
module connectors.
You can rearrange or remove any of the plates mounted on the inner frame and replace them
with Kramer passive wall plates or connector modules for interfacing A/V type signals.
To mount a Kramer insert or connector module:
1. Unscrew the two screws that fasten the blank plate to the inner frame and remove the
blank plate.
2. Place the required Kramer insert over the opening, insert the two screws to fix the Kramer
insert in place, and tighten them.
Installing the Assembled Inner Frame
To install the T6F-23 inner frame:
1. Place the assembled inner frame inside the TBUS-6xl enclosure.
2. Set the required height using your fingers to bring the inner frame to the desired position,
screw and tighten it in place using the height adjustment screws supplied with the inner
frame.
Connecting the Cables
When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and so on):
1. Insert the cables to their appropriate connectors from underneath.
2. Secure the cables to the tie holes on the TBUS-6xl.
Do not secure the cables too tightly or too loosely. Leave a small amount of slack.
After the TBUS-6xl is connected to mains power and the proper cables, it is ready for use.