Filter
Top Products
149
Technical Notes
Cleaning
Lens/ Viewfi nder
One key to preserving the conditions of these glass parts is to not touch
them with your fi ngers. Remove dust or lint with a blower (typically a small
device with a rubber bulb attached to one end that is pumped to produce a
stream of air out the other). To remove fi ngerprints or other stains that can
not be removed with a blower, wipe the lens or viewfi nder with a soft cloth,
using a spiral motion that starts in the center of the lens and works out to
the edges.
Monitor
Remove dust or lint with a blower. To remove fi ngerprints and other stains,
clean the monitor with a soft, dry cloth, being careful not to apply pressure.
Avoid contact with liquid crystal
Should the monitor break, care should be taken to avoid injury due to broken
glass and to prevent the liquid crystal from the monitor touching the skin or
entering the eyes or mouth.
Body
Use a blower to remove dust and lint, then wipe gently with a soft, dry cloth.
After using the camera at the beach or seaside, wipe off any sand or salt with
a cloth lightly dampened with fresh water, then dry thoroughly.
Do not use alcohol, thinner, or other volatile chemicals.
Notes on the Monitor
• The monitor may contain a few pixels that are always lit or that do not light. This is a
characteristic common to all TFT LCD monitors, and does not indicate a malfunction.
Images recorded using the product will not be affected.
• When you frame bright subjects, vertical comet-like streaks that whiten toward ei-
ther end may appear in the monitor. This phenomenon, known as “ smear,” does not
appear in the fi nal photograph and does not indicate a malfunction. Some smear
may appear in movies.
• Images in the monitor may be diffi cult to see in a bright light.
• The monitor is lit by an LED backlit. Should the monitor begin to dim or fl icker, con-
tact your Nikon service representative.
Caring for Your Camera